ICON I-DJ Owner's manual - Front Panel Layout
4
Front Panel Layout
Crossfader
This slider controls the crossfader at your software. Slide to control the
transition between songs. The crossfader curve setting is adjustable.
Please refer to the “C.F.Curve” button below for details.
C.F.Curve / Layer button
This is a multi functional button. It can be used to adjust the crossfader
curve, switching the layer from one to four or restore the iDJ to factory
default settings.
Adjust the crossfader curve
Activate the button (red light turns on) and slide the crossfader to your
preferred cross point. This would be your “A” cross point and “B” cross
point will be mirror symmetric. The section between your cross points “A”
& “B” is the center value.
Tip: In general, a gentle curve is more suitable for long mixes (larger distance between A/B
as diagram A shown) and a sharp curve is more suitable for scratching (i.e. less distance
between A/B as diagram B shown).
Switching between the 4 layers
You may pre-map your iDJ to 4 layers with different midi mapping at each
layer. To switch between these layers, activate the Layer button and press
the 4 buttons below to change the layers from 1 to 4.
Restore iDJ to factory default
Press and hold the button for more than 3 seconds (all the iDJ lights will
flash one time), this will restore all iDJ settings to factory default values.
User defined buttons
These buttons are intended for user to self-define the usage. Please use
iMap software to assign their functions.
Tip: Except “Vinyl Mode”, “C.F.Curve”, “CUE” & “Play/Pause” buttons are not assignable,
all other buttons, sliders and knobs on your iDJ are assignable with the provided iMap
MIDI mapping software.
9
10
11
Diagram B
Diagram A
Centre
(Centre)
(Centre)
A
B
AB