Interserve 650, 660 late-breaking news june 1998 dha0203g0
Copyright 1998 intergraph computer systems. All rights reserved. This document contains information protected by copyright, trade secret, and trademark law. This document may not, in whole or in part, be reproduced in any form or by any means, or be used to make any derivative work, without written ...
1 general setting up your system for the first time when setting up your system for the first time, you should do so as follows: 1. Set up the basic system hardware as described in the system documentation. However, do not connect any external peripherals to the system’s scsi ports. 2. Start the sys...
2 4. Do one of the following, as appropriate: − change the value to enabled to limit memory use to 2 gb. − change the value to disabled to use all of the system’s memory. 5. Save the change and exit from bios setup. 6. Restart the system. You can also reset the bios to optimal to use all of the syst...
3 controllers pci slot order power console bios configuration 4 4 1st 0 0(boot) 5 2nd 1 3 6 3rd 2 2 7 4th 3 1 booting a system with raid controllers interserve 650 and 660 are shipped with raid disk array controllers installed in pci slots 4 through 7 (in ascending order). The raid controllers shoul...
4 inserting a power supply when inserting a power supply into a running interserve 650 or 660 (for example, when replacing a failed power supply), push the supply completely into the system. Once the supply is fully seated, close the extraction lever. If the supply does not power on, simply pull the...
5 windows nt 4.0 installing the adaptec scsi controller driver if you have to reinstall windows nt 4.0, be sure to reinstall the driver for the scsi controller (2940 scsidrv ) from backup diskette during setup. To install the 2940 scsidrv driver during setup: 1. When prompted, press s to bypass dete...
6.
