Intergraph RealiZm II Graphics Hardware User's Manual - Starting Windows Nt
3
For a single-screen configuration:
Connect the monitor cable to the blue video port shown in the following figure. In this sample
configuration, the numbers on the left show numbering of the workstation’s expansion slots,
so the RealiZm II card is in slot 3.
For a multi-screen configuration:
Connect a monitor cable from each monitor to the blue video port on a RealiZm II card. After
you start the system, you may have to switch cable connections to the RealiZm II cards if the
screen display is not correct. For example, in a side-by-side monitor configuration, if the right
half of the Windows NT desktop displays on the left screen, and the left half of the desktop
displays on the right screen, switch the cable connections to the RealiZm II cards.
Starting Windows NT
After setting up a workstation equipped with RealiZm II cards, or after upgrading or replacing
RealiZm II cards and associated components as described in Chapter 2, you can turn on
system power and start the Windows NT operating system.
CAUTION
Make sure the monitors are connected to the proper ports on the RealiZm II cards before
applying power to the monitors and to the workstation base unit.
To start Windows NT:
1. Turn on power to the monitor(s) and to the workstation base unit.
2. At the boot screen, select the non-VGA version of Windows NT.
Blue Video Port
Black VGA Input Port (not used)
0
1
2
3
4
5
6
7