Intergraph RealiZm II Graphics Hardware User's Manual - page 17
9
3. Remove the DIMM access cover.
4. Remove a DIMM from its static protective bag.
CAUTION
Do not bend, twist or drop DIMMs. They may be damaged as a result.
5. Align the DIMM notches with the keys in one of the texture memory sockets on the card,
and insert the DIMM into the socket. Refer to the following figure.
6. Push on the top edge of the DIMM until it snaps into the socket. Refer to the following
figure.
7. Repeat steps 4 through 6 for the second DIMM.
NOTE
For proper operation, you must install DIMMs of th e same memory size in both sockets.
8. Replace the DIMM access cover.
9. Replace RealiZm II the card into the system.
10. Close the system base unit.
11. Turn on system power and log on to the Windows NT operating system.
12. Open Display in the operating system Control Panel. The Intergraph Settings tab of the
Display Properties dialog displays the proper texture memory size. If not, shut down and
power off the system. Ensure that both DIMMs are properly seated in their sockets, and
that both DIMMs are the same memory size.
Texture
Memory
DIMM