Interlogix TVB-1101 Installation Manual - Accessing The Sd Card
16 Installation
Guide
3.
Set up the camera’s network and streaming parameters
so that the camera can be controlled over the network.
For further information, please refer to the “TruVision IP
Camera Configuration Manual”.
4. Program the camera to suit its location. For further
information, please refer to the “TruVision IP Camera
Configuration Manual”.
Accessing the SD card
Insert a Micro SD card with up to 64GB for local storage as a
backup in case, for example, the network fails (see Figure 1
on page 11). An SD card is not supplied with the camera.
For the IP VF dome camera, point the lens vertically upwards
to access the SD card slot.
For the IP VF bullet camera, remove the sunshield and open
the front cover to access the SD card slot.
Video and log files stored on the Micro SD card can only be
accessed via the web browser. You cannot access the card
using TruVision Navigator or a recording device.
Note: There is no Micro SD card slot in the mini bullet and
indoor mini dome cameras.
Mounting the mini bullet camera
To mount the mini bullet camera on a ceiling or wall:
1. Use the supplied template to mark out the mounting area.
Drill the screw holes on the ceiling or wall. If you need to
route the cables from the camera base, cut a cable hole
in the ceiling or wall.