Intermec 200 Quick Reference Manual - Command Descriptions
CODE
CODE(".-
(".-NUG
NUG
3270 and 5250 Commands
4-3
4
This chapter lists all of the terminal emulation commands you can use with 3270 and
5250 terminals.
Command Descriptions
IMPORTANT!
To scan the bar code labels in this chapter, you must configure your
JANUS device to use Code 39 in Full ASCII mode.
This chapter contains an alphabetical listing of the 3270 and 5250 terminal
emulation commands that you can use on your JANUS device. Each command
contains a description, key sequence, and bar code. You will also find program
function and program attention keys listed with their associated bar codes, but
no function description because you can program the keys differently for each
application.
Arrow Keys
Arrow keys move the cursor one space up, down, right, or left. You can move
the cursor to any place on the display, even within protected fields. To select a
specific arrow key, press one of the arrows on the edges of this key.
Keypad:
F
Scan:
N/A
Attention
The Attention key contacts the host and asks permission to send data from the
JANUS display. The keypad locks automatically when you send this command
or any other AID command. When the host computer grants permission to
send data, the keypad unlocks. This key is useful for finding out if the host
computer is free before you attempt to transmit data.
For 5250 terminals, this key sequence prompts the host system to display the
Operational Assistant Menu.
Keypad:
Scan:
Attention
*/EATTN*
*%ATTN*