Intermec CN3 Series Installation Instructions
Other manuals for CN3 Series:
User Manual, User Manual, Supplementary Manual, Instructions, User Manual, Supplementary Manual, User Manual, Instructions Manual, Quick Start Manual, Quick Start Manual, Supplementary Manual, Supplementary Manual, User Manual, Instructions Manual, User Manual, User Manual, User Manual, User Manual, User Manual
of
2
Spacers are installed on the CN3 terminal holder to allow for optimum fit of the
holder on the 6822 portable printer.
To install the spacers
1 Center a spacer on each mounting post and press firmly to seat.
2 Align the terminal holder on the printer and insert the screws in the four
mounting holes.
3 Using a Phillips screwdriver, tighten the screws to 0.45 to 0.68 Nm (4 to 6 in-lb).
CN3
Terminal Holder Spacer Installation
Instructions
Screw (4 places)
Spacer
(4 places)