Intermec Janus 2020 Quick Start Manual - Mounting The Battery Charger
JANUS 2020 Battery Charger Quick Reference Guide
7
Installing the Battery Charger
1. Mount the charger on a desktop or board. (Optional.)
2. Connect the power supply to the charger.
Mounting the Battery Charger
You can permanently mount the battery charger on a desktop or board using
two 4 - 40 UNC 2A screws as shown. Mount the charger before you connect the
power supply.
Note:
If you mount the JZ2020 battery charger on a table top or shelf, make sure you
have a vertical clearance of at least 8.0 inches (203 mm) above the charger so that you
can insert and remove battery packs easily. Also remember to leave space behind the
charger so that you can connect the power supply and reach the discharge button on the
back panel.
Connecting the Power Supply
The battery charger uses the Intermec Part No. 058399 power supply, which
has a detachable power cord. The power supply operating range is 100 to 240
VAC at 47 to 63 Hz. To connect the external power supply, attach it to the
power supply connector on the back panel of the charger and plug the power
supply into an AC outlet.