J. A. Roby auster RGCG-25 Installation And Operation Manual - page 46
46
Remote control’s LCD screen:
4.2.1
REMOTE CONTROL AND FIREPLACE SYNCHRONIZATION
•
Push button 1 (figure 4.2.1.b) completely to the right.
•
Remove a battery from the remote control (figure 4.2.1.a)
•
Press the PRG button (button 2 in figure 4.2.1.b). You will hear three beeps.
•
Place the battery back in the remote control. You will hear three beeps again.
•
Put button 1 (figure 4.2.1.b) back in the center position.
•
The remote control is now synchronized.
•
Press the ON/OFF button on the remote control to turn the fireplace on (figure 4.2.2.).
CAUTION:
The remote control and the receiver are radio frequency devices. Placing the receiver in or near metal may
considerably reduce the range of the signal.
Figure 4.2.1.b
Figure 4.2.1.a