J. A. Roby auster RGCG-25 Installation And Operation Manual - page 49
49
Definition:
•
CPI Mode: The CPI mode keeps the
pilot turned on permanently, no
matter if the burner is turned on or
not.
•
IPI mode: During IPI mode, the pilot
only turns on to ignite the main
burner and when the fireplace is
operating.
Keylock:
This function locks the keys to prevent any unsupervised use.
A padlock is shown on the remote display when activated. (Figure 4.2.2.f)
To activate this function, press the Mode button and the upward arrow button at the
same time.
To deactivate this function, press the Mode button and the upward arrow button at
the same time.
Low battery alarm
How long batteries will last inside the remote control depends on several elements:
battery quality, how many times the appliance has been turned on, how many times
the room thermostat set temperature was changed, etc. When batteries are low, a
battery symbol appears on the LCD screen of the remote control to warn you before
the batteries die. This symbol disappears once the batteries are replaced.(Figure
4.2.2.g)
Figure 4.2.2.f
Figure 4.2.2.g
Figure 4.2.2.e