J3 Competition kosmic Manual - page 15
J3 Competition Inc. – Kosmic Owner’s Knowledge Packet
15 |
P a g e
12d. Brake Bleeding
When bleeding your make sure have the proper OTK brake bleed kit (PN 0156.00). This
tool enables for and effective and efficient job. Here are the steps required.
1.
Take a 5mm Allen wrench and remove the braking pumps discharge plug
2. Insert your OTK Bleeding Kit by carefully begin screwing it into the fitting.
3. Once secure, remove the top cap on the Bleeding Kit and turn the valve to the
‘On’ Position’
4. Now, move to the rear caliper and underneath the bleeding screws place a rag (in
order to absorb any residue and spillage).
5. Once complete remove the bleeding screw and let the bleeding kit force all the air
out of the brake line
6. Once the air appears to be gone, insert the bleeding screw.
7. Repeat this step for each brake pump on the chassis
8. When finished make sure that you have securely tightened the discharge plugs.
*Highlighted are the Bleeding Screws on the various caliper models
3mm Allen
8mm Wrench
8mm Wrench
Pump’s Discharge Plug (5 mm Allen)