J3 Competition kosmic Manual - page 23
of
23
www.conerel.com
already done.
6. Change the axle to Type C.
The kart is tight at the exit of the corner or the
front end is understeering at the exit of the
corner.
1. Put shorter wheel hubs on the axle.
2. Move in the rear track by 1/2 inch.
3. Lower the air pressure in the rear tires by 1 psi.
4. Change the axle to Type N if not already done.
5. Lower any ballast to a lower vertical position at
the rear of the kart.
6. Remove one set of seat struts.
7. Lower the rear ride height.