Jablotron Oasis User Manual - page 14
10. Programming the master code (card)
The master code is used by the house owner or administrator (supervisor). The
factory default setting is 1234. The administrator should program his/her own
four-digit code while taking the system over from an installer. This prevents
other parties from accessing the system configuration. Master code
programming is only possible when the system is unset (disarmed) and not
in maintenance mode.
To change an existing master code enter:
* 5 xxxx yyyy yyyy
where
xxxx is the existing master code
yyyy is the new master code (the new code must be entered twice to
avoid errors). Combination 0000 cannot be used. The master code cannot be erased.
Example:
Existing code 1234 will change to 6723 by entering: * 5 1234 6723 6723
If you wish to use an access card instead of a code, you can enter * 5 xxxx and
then present the card. This makes the card authorized for system configuration.
If you forget the master code (or if you lose the card),
an installer can reset the code to the factory default
setting 1234 (this requires the system to be unset
(disarmed). All other pre-programmed codes (cards) in
the system remain unaffected.
11. Programming user codes (cards)
The system allows for up to 50 different access codes (cards). Their modification or
deletion is only available to the system administrator who knows the master code.
The most comfortable way to edit the user code is via Olink software.
Code programming is only possible when the system
is unset (disarmed) and not in maintenance mode.
In practice, it is convenient that each user has his own user code pre-
programmed. The system stores to its memory which code was used for what
Oasis user manual
10
MKE22102