Jablotron Oasis User Manual - Access Codes And Cards
The Oasis system is configurable and its exact behaviour
is determined by system settings. The following text
contains references to the system configuration table
which is to be found at the end of this manual. The table
should be filled in by an installer during the installation
process. References are numbered, like for instance (
4.). In this case you can find particular settings for the 4th
parameter in the table.
System access codes (cards)
The system status can be controlled via a keypad (internal or external) using
access codes or cards. To prevent misuse by a stolen card, you can set that card
access must be confirmed by entering a proper code (
5.). In addition, you can
operate the system wirelessly by key-fob or remotely via phone or using
internet access (see www.GSMLink.cz).
Access codes and cards
Access codes and cards allow system operation – i.e. setting (arming), unsetting
(disarming), stopping triggered alarms, triggering silent alarms (PANIC), etc.
Access code functionality can be configured during installation. The system allows
for up to 50 different access codes (cards) to be assigned to different users. This
way it is possible to distinguish (at the alarm receiving centre or in the control panel
memory) who has operated the device and when. As a factory default, all access
codes are blank. It is up to you – the system administrator (master) – to define
access codes as desired, using a Master code or card.
Note: Entering an invalid access code ten times in a row will trigger a tamper alarm.
The Master code (card)
The master code (card) is an access code or card with a higher priority which, in
addition to allowing system control, enables you to change or configure access
codes for other users. Knowing the master code or possessing a master access card
is necessary for any user configuration of the system.
Usually, the master code is used by the system owner
or administrator, who performs a change of the factory
default value 1234 to his or her required master code
after taking the system over from the installer. An
access card can be set up in place of a master access
code. This should be kept in a safe place.
Oasis user manual
3
MKE22102