Jackson MSC JP-24B Service Manual - page 9
INSTALLATION REQUIREMENTS continued
HOT WATER SUPPLY CONNECTION
Install the water supply line (1/2" pipe size minimum) to the dishwasher line strainer using a soft copper
tube, flexible tube or hose to allow machine to be moved for servicing.
DISHWASHER ELECTRICAL DATA DECAL
DISHWASHER ELECTRICAL DATA DECAL is located on the right-side of unit at front. Refer to the
electrical data decal for machine operating requirements, machine voltage/total amperage load, and serial
number.
CHEMICAL DISPENSING EQUIPMENT
The JP-24 series dishwasher is not supplied with dispenser pumps for detergent, rinse additive or sanitizer
(JP-24LT/F). An injection hole is provided in the back wall of machine for dispensing detergent into
dishwasher wash tank. An injection manifold is provided in the final rinse line for injecting rinse additive and
sanitizer (Model JP-24LT/F requires a minimum of 50 PPM of 5.25% sodium hypochlorite (liquid bleach) be
injected in the final rinse line during the rinse).
Electrical power and signal source for detergent, rinse additive and sanitizer (JP-24LT/F) dispensing
equipment are available as follows:
DETERGENT SIGNAL - White/Red wire, "L1" signal (line voltage) for detergent dispensing. Detergent
dispenses during rinse cycle.
DISPENSER POWER - Red wire, "L2" return (line voltage). DISPENSER MAXIMUM AMPERAGE LOAD:
FUSE-TYPE 3AG "SLO-BLO", 2.5 MAXIMUM.
DISPENSER POWER - Green/White wire, "L1" power (line voltage) during dishwashing cycle. RINSE
AGENT/SANITIZER - Blue wire, "L1" signal (line voltage) (parallel with rinse/fill solenoid).
7