Jacobsen Ransomes HR 6010 Service Course Manual - Height of Cut
HEIGHT OF CUT
ADJUSTMENT
(WING DECKS)
The cutting height is determined by the
position of the blades in relation to the caster
wheels. Changes to this height are made at
(4) points and can be made in any order. Make
selections for each adjustment below from the
accompanying height of cut charts .
1.
Raise the deck.
2.
Remove the quick pin Q from the
top of the caster wheel pivot
spindle.
3.
Remove the caster wheel from
caster support M.
4.
Select either Position 1 or Position
2 for wheel mounting bracket. To
change, remove (4) mounting bolts
R.
5.
Place the selected size and
number of spacers below the
caster support. Both A-size (6.5
mm) and B-size (12.5 mm)
spacers are provided. Place the
remaining spacers above the
caster support.
6.
Replace the quick pin.
7.
Place pin P into proper hole of
front caster bracket for the se
lected height of cut.
8.
Place chain pin T into the proper
hole of chain adjustment bracket
for the selected height of cut.