Jacobsen Ransomes HR 6010 Service Course Manual - page 20
Coolant Change
1.
Completely drain the cooling water
from the radiator and flush the
cooling system with flushing deter
gent. Drainplugs A.
2.
Check for leaks or loose connec
tions at the radiator, cylinder head
gasket, etc.
3.
Open screw valve B fully.
4.
Fill cooling system with recom
mended water / antifreeze to the
required level.
5.
Close screw valve.
6.
Run engine.
7.
Open screw valve & top up if
necessary.
Note: When topping up the cooling
system fill with 50/50 solution.
Fig.15
Fig.15A
Cooling System.
Check Bug Screen (F) Radiator & Oil cooler
are all free from dust /debris and there is an
uninterrupted air flow to the engine. The
screen should be fitted with the mesh facing
the front of the machine. Any debris should
be removed with a soft hand brush.
Machine Maintenance.
Fire Hazard: Remove all debris from under
the seat plate and from within the engine
compartment. Area. (G)
F
PRE-CLEANER.
Check Pre-Cleaner is free from debris.
This is by removing the Wing Nut &
Washer from the top of the Pre-Cleaner.
The Cover (A) & Bowl (B) can then be
removed from the body, the Bowl (B)
can then be cleaned out.
A
B