Operator's manual 09/2005 - 391904 - 0349-mi mÁquinas agrÍcolas jacto s.A. - jacto cleaning av. Perimetral, 901 - distrito industrial cep: 17580-000 - pompéia -sp - brasil tel.: +55 14 3405-2100 - fax: +55 14 3452-1306 e-mail: export@jacto.Com.Br home page: www.Jacto.Com.Br cleaning system high pres...
Table of contents introduction .......................................................................................... 04 important an information to the user ...................................................... 05 presentation of the equipament ....................................................
Introduction the jacto high pressure cleaning machine model 8000 was designed to clean, remove the grease of industrial and agricultural machinery, vehicles, remove dirts from metallic structures and other applications that require high pressure jets. It is available in the following versions - sing...
24 important information to the user before using the jacto high pressure cleaning machines model 8000, read carefully and follow strictly the instructions given herein. You must maintain all the decals in the right place and replace any of them if illegible. Avoid accidents by working carefully. At...
Important information to the user on the use - never switch on the machine without supply of water or solution. - the machine must not be running for more than 5 minutes with the gun in closed position to prevent pump overheat. (machine with trigger) - in switching off the machine, pull the gun trig...
22 identification plate on the lower part of the chassis there is a plate containing information on the machine model, serial number, working pressure, motor voltage and other important data. In requesting spare parts and service, always specify the machine model (1) and serial number (2) for prompt...
Technical specifications 08 21 electric diagram high pressure cleaning machine - model 8000 (220 v - single-phase) high pressure cleaning machine model 8000 three-phase single flow rate (maximum)............. L/min pressure (maximum)..................Psi power consumption............Cv / kw current....
20 assembly extension (2) assembling the trigger gun - fit the gun body (1) in the opening on the gun extension (2). - press the extension against the gun, rotate the locking nut (3), and make sure the parts are properly fitted. Gun boddy (1) nut (3) 09 trouble-shooting problem damaged seals on suct...
Water supply direct from the water tap - the minimum flow rate of the tap must be 11l/min. Note: to check the flow rate of the tap, collect water in a recipient during 01 (one) minute. The water collected during this time must not be lower than 11liters, under the risk to damage the pump. - use rein...
18 water supply from a tank suction hose (maximum length: 2.00 meters) tank before starting the cleaning, fill the suction hose with water or solution in order to facilitate the elimination of the air from the hose and, consequently, from the pump head. It can be necessary to attach a non-return val...
Power supply cable with ground plug this equipment is assembled with a 3-prong ground plug (single-phase), and cable with 4 wires (three-phase). The round prong (single-phase), as well as the green wire (three-phase), is connected to the socket that is directly connected to the ground wire of the po...
16 13 attention -the machine has a device that switchs off the motor automatically in case of current overcharge. - in this case, expect from 3 to 5 m i n u t e s b e f o r e s w i t c h i n g o n t h e machine again. - if it occurs once again, check the voltage of the power supply. - if the problem...
Maximum level operation procedures for using - check the oil level and complete, if necessary, a c c o r d i n g t o i n s t r u c t i o n s i n t h e s e c t i o n "maintenance". - before connecting the high pressure hose, pulse (swith on and off) the motor several times to eliminate the air from t...
