Jacto 8000 Operator's manual - page 10
WATER SUPPLY
DIRECT FROM THE WATER TAP
- The minimum flow rate of the tap must be 11L/min.
NOTE: To check the flow rate of the tap, collect water in a recipient during 01
(one) minute.
The water collected during this time must not be lower than 11liters,
under the risk to damage the pump.
- Use reinforced hose (nominal diameter of 13 mm - 1/2") to prevent it from
shrinking, what can damage the operation of the machine.
reinforced hose with
ø 13 mm (1/2")
water tap
10
19
Only use wet cloth to clean this equipment. Never use water, since it can
damage the components. The machine hood must not be cleaned with thinner or
similar substances.
In regions where the temperatures are low, after using the machine, it is
necesssary to drain completely the pump head to avoid damage.
PROCEDURES
Disconnect the suction hose (1)
first and then the high pressure hose (2).
Switch on the machine for 10
seconds and make sure the water or
solution has been expelled.
Install the hoses on the machine.
1
2
After finishing the cleaning of the machine, store it in a dry and covered
place.
CLEANING AND STORAGE