Jacto 8000 Operator's manual - page 11
18
WATER SUPPLY
FROM A TANK
suction hose
(maximum length: 2.00 meters)
tank
Before starting the cleaning, fill the suction hose with water or solution in
order to facilitate the elimination of the air from the hose and, consequently, from
the pump head.
It can be necessary to attach a non-return valve to the suction hose end
that will be under water or solution so that the hose is always filled with water or
solution. This non-return valve is not supplied with the machine.
11
ATTENTION
- The machine must be on the same level of, or on a level below, the tank.
Do not place the machine at a height more than 1 meter above the water
level.
- The machine is not supplied with the suction hose.
MAINTENANCE
DECALS
JACTO affixes the decals shown below aiming to direct the use and
maintenance of this equiment, as well as to indicate places of danger.
These decals must be kept legible and in their correct place, because
they are very important for the safety of the operator and persons working or
standing around the area being cleaned.
ATTENTION:
IN CASE THE DECALS ARE DAMAGED OR ILLEGIBLE, YOU MUST
REPLACE THEM BY ORDERING THROUGH THE P/N INDICATED.
non-return
valve
P/N: 498154
P/N: 498163
P/N: 682740