Jade Built-In Refrigerators Design Manual - page 10
Leveling
Slide the unit in place and raise the front and rear
levelers until the unit touches the brackets. Use a
3
⁄
8
" socket for raising and lowering the unit. On each
wheel housing, there are two
3
⁄
8
" hex bolts. On the
left side, the outside bolt will move the rear leveler
and the inside bolt will move the front leveler. On
the right side, the outside bolt will move the front
leveler and the inside bolt will move the rear leveler
(FIG. 5). The front levelers must be in contact with
the floor. To raise the leveling legs, turn the hex
screw counterclockwise. Place level on lower ledge
of the machine compartment. Level the unit front to
back and side to side to prevent tipping of the unit
(FIG. 4). Install the kickplate. The kickplate must be
removable to allow access to the water valves. In
the machine compartment there is an on/off power
switch. Make sure the switch is in the ON position
and switch lever is up. Install the upper cover.
FIG. 5
Optional:
If
you
are
attaching
the unit to cabinetry, drill three
3
⁄
16
"
holes through both outer trims. Drill
1
⁄
8
"
pilot holes into the cabinetry. Install screws.
Additionally, if the depth/height of opening is excessive, use the steel
hanger strap. Double over strap at the anchor points to secure cabinet.
I N STA L L AT I O N G U I D E – P R O P E R P OS I T I O N I N G
1
1
/
4
" (3.2 cm) vertical adjustment for leveling and height adjustments.
8