Jade Built-In Refrigerators Design Manual - page 17
I N STA L L AT I O N G U I D E – I N STA L L I N G PA N E L S
O N D I S P E N S E R M O D E L S
1.
Power switch needs to be off. Switch is
located in machine compartment area
(see User Guide).
2. Remove magnetic strip on door handle.
Use of tape may be required to remove
magnetic strip. (See FIG. 10a on page 17.)
3. Remove four Phillips screws to remove
door handle/trim. (See FIG. 10b on
page 17.)
(Refer to numbered illustrations for steps 4 — 10)
4. Remove the spill tray grille from the
fountain.
5.
Remove the two #15 Torx machine screws,
that retain the stainless steel splashguard.
Remove the splashguard.
6. Remove the two #15 long plastic Torx
screws that retain the fountain control
panel. Slide control panel down to remove.
Disconnect the electrical terminals
going to the fountain control panel. Tuck
dispenser terminal inside to avoid
interference.
7.
Remove the four #15 plastic collar Torx
screws from the fountain/escutcheon
collar.
8. Place
the
fountain/escutcheon collar
onto the backer panel. Use tape to hold
in place.
9.
Open the freezer door and slide panel
onto the door.
10. The holes in the fountain/escutcheon
collar should line up with the mounting
holes in the door panel. Reverse
instructions 7 to 1: Replace the four
#15 plastic collar Torx screws in connect
the fountain escutcheon collar, the
electrical terminals, and so on.
Freezer Dispenser Panel Installation
4
5
6
7
8
9
10
15