Jade Built-In Refrigerators Design Manual - page 9
Blocking and/or Anchoring the Refrigerator
If there is a solid soffit above the unit and the clearance is 1"
(2.5 cm) or less, you will not need to block the unit. For installations
with clearances of more than 1" (FIG. 3), you must use the anti-tip-
ping 2 x 4 and brackets provided (FIG. 4).
More than 1" (2.5 cm) Clearance:
Use the anti-tipping kit provided with the shipping crate. Locate
and mark the two wall studs behind the unit. Mark where the
"L" brackets and 2 x 4 will be located and drill two
1
⁄
8
" pilot holes.
Locate the proper height to clear the unit. The space between the
top of the unit and bottom of the wood block must not exceed
1
⁄
4
" (0.6 cm). Secure the L brackets into the wall studs using the
provided screws (
1
). Make sure the screws will extend
7
⁄
8
" (2.2cm)
into the wall studs. Align the pilot holes with the L brackets and
secure the 2 x 4 with the screws provided (
2
,
3
).
I N STA L L AT I O N G U I D E – P R O P E R P OS I T I O N I N G
FIG. 3
FIG. 4
Adjusting Door Hinges
Check to make sure the doors are properly adjusted. If not,
adjust the top and bottom hinges. The hinges are slotted for
side-to-side movement. First, remove the small Phillips screw
on the door hinge, which is inboard on the hinge, and throw
it away. Adjust the upper and lower hinges by loosening the
three large Torx screws. Tighten the screws after the doors are
adjusted. Door handles can be adjusted to level top handle
trim. The doors are slotted for handle alignment.
7