Jadever JKD 250 User Manual - page 4
JADEVER SCALE CO., LTD
JDI SCALE
4
Beep up=
There will be a warning sound when the weight/ quantity of articles
exceed the upper limit.
Beep in =
There will be a warning sound when the weight/ quantity of articles
is
between
the
upper
Beep low=
There will be a warning sound when the material weight/quantity is
less than the lower limit
2) SerialSet—Set serial number
3)
Accuracy:
Press to initiate accuracy and maximum capacity of the main
scale and remote platform.
Main scale:
JDI scale
Remote platform:
floor scale or platform scale
Note:
◎Resolution 600-300000
◎JDI-800 indicator can connect two scales simultaneously
4)
QTY CK-- Quantity Checking:
Use this mode to compare the quantity of
weighing item to Lower and Upper limits.
5) UnitsSet:
Sets Unit of measure
Note:
Under the weighing mode, press and hold
GROSS/NET
key to enter
unit setting directly.
6)
Zero Range:
Sets the range in which the Zero indication turns on. Options
are D0 (1 division), D1 (2divisions), D2 (3divisions), D3 (4 divisions), D4
(5divisions) and D5 (6divisions).
7)
Auto Tare:
Deducts the value of the container when it’s within the pre-set
values.
8)
ACC Set --- Accumulation setting:
Sets the maximum accumulation
items and accumulation method.
Stable ACC=
Automatically accumulates stable weighing.
Weight OK ACC=
Automatically accumulates weighing which are between
upper and lower limits.
Count OK ACC=
Automatically accumulates quantity of the material which is
between the upper and lower limit.
Manual ACC=
Manual accumulation, press to accumulate weighing.
9) FilterSet:
Sets filter level. The higher setting and the better shockproof.
10) Commport:
Choose the communication port
11) CommMode:
Choose the communication mode to Jadever weighing
software
5. STOCK Menu
After connecting to network, you could use this function for stock control.