JAGER PRO M.I.N.E. Operation Manual - Control Box Receiver
18
TIMING CAMERA TRANSMITTER TO
CONTROL BOX RECEIVER
THIS STEP IS ONLY A FUNCTION OF THE 3G M.I.N.E.™
CAMERA. THE 3G I.C.E.™ CAMERA DOES NOT UTILIZE AN
INTERNAL TRANSMITTER.
The 3G M.I.N.E. Camera has an internal transmitter on the circuit board and
must be located within 50 meters of the M.I.N.E.™ Gate to operate correctly.
Users must manually calibrate the camera transmitter signal to each control
box receiver the first time they are paired together. One camera will operate
multiple control box receivers to trigger multiple gates simultaneously at a
trap enclosure.
1. Move camera selector switch from
OFF to SETUP.
2. Open control box housing and
press
(A) receiver button. The
receiver red light will only emit for 10
to 15 seconds.
3. Press the camera
(A) left arrow
and release then press the camera
(B) right arrow and release to send
a manual RF signal to the control
box. The receiver light should flash
three times and shut off if performed
correctly. Conduct a test by repeating
this step, the latch will activate.
Repeat these steps on other control box receivers if multiple gates are used
at the trap enclosure. Move camera selector switch from
SETUP to ON and
send SMS text command
*777# to test transmitter and receiver calibration
and gate operation.
A
B
A
If you have any questions, refer to the
JAGER PRO™ M.I.N.E. & I.C.E. (3G)
Camera Operations Video at 18:41 TIMING CAMERA TRANSMITTER TO
CONTROL BOX RECEIVER for more information.