James 9050 Touch User Manual - Operating Guidelines
12
OPERATING GUIDELINES
Remove the cover and put it on the cover holder vertically.
Put the items in the basket then put them in the cleaning
tank. Add water to a level between “MIN” and “MAX” and
above the area to be cleaned.
If the unit is turned on without water, ultrasonic
energy will not be absorbed. This model has high
power and once on for over 15 seconds, it may
damage the unit or severely reduce the life of the unit.
Connect the power cord to an outlet and turn the
switch on. LED display shows
. This is the
most common timer setting. If the timer needs to
be adjusted, press Time button. Select desired
timesetting by pressing Time button:
10min - 15min - 20min - 25min - 30 min - 5 min
Prolonged cleaning time may result in:
a. Loosening of the screws if used.
b. If items are plated and have existing cracks, the
cracks may become more pronounced.
c. Coatings with pre-existing damages may experience
more peeling.
Press On/Off button to start cleaning.
The digital timer will count down to show the remaining
cleaning time. When it displays
, the cleaning is done.
To stop cleaning at any time, press On/Off button.
The unit is designed with overheating protection.
If the unit has been running for too long, the red warning
light ‘ ’ will illuminate, indicating the unit is in overheat
protection mode. The unit can not be operated until it has
cooled down (~15 to 20 minutes). The ‘ ’ turns off and the
operation can be resumed
1
2
3
During cleaning, buzzing sound can be heard from the
cleaning tank, indicating that the cleaning is underway.
Closing the lid will reduce the noise level.