James 9050 Touch User Manual - Control Panel and Operations
7
CONTROL PANEL AND OPERATIONS
1.
– Working Time Display. It counts down after work has started.
2.
– Multistage Thermometer.
Solid green light indicates that the water temperature is
0-30% of the set temperature.
Solid orange light indicates that the water temperature is 30-60%
of the set temperature.
Solid red light indicates that the water temperature is 60-90% of the set
temperature. Flashing red light indicates that the water temperature is close to the set temperature.
All lights on, indicate that the water temperature is at the set temperature (90-100%).
3.
– Set Temperature Display. Press Temp button to select one of the 3 set temperatures.
50°C or 122°F 55°C or 131°F 60°C or 140°F
4. – °C or °F Indicator.
°C - Set temperature in °C. – ° F - Set temperature in °F.
5. – Overheat protection warning light. If the unit is working improperly or has been running for too
long, the red warning light
will illuminate, indicating that the unit is in overheat protection mode.
The unit can not be operated until it has been left to stand (~15 to 20 mins) to cool down. The warning light
then turns off and the operation can be resumed.
6. – Heater Status. Press Heater button, flashes, indicating the heater is turned on. Press Heater
button again, dims, indicating the heater is turned off.
7. – Normal Cleaning Status. – Illuminated, normal cleaning is underway.
8.
Heater Button. Pressing heater button, flashes, indicating that the heater is turned on.
To cancel heating, press heater button twice again, dims, indicating the heater is turned off.
9. Temperature Set Button. 3 set temperatures (°C/°F) can be selected. Press Temp button to select one of
the 3 set temperatures.
50°C or 122°F 55°C or 131°F 60°C or 140°F
10. Function Button. After powering on, the LED displays
which is the default time (as
shown), and the unit is ready for normal working status. Press On/Off button twice and the
cleaning starts. The cleaning stops when the timer counts down to
. If the unit needs to
be stopped before the timer runs out, press On/Off button twice.
11. Timer Quick Set Button. Press Timer button, LED display shows
. Each pressing increases the
time by 5 minutes.
When the water reaches the set temperature, the heater will turn off automatically.
To prevent accidentally turning on or off the heater, the Heater button needs to be touched twice
within 6 seconds to turn it on or off. flashes, indicating the heater is on.
To prevent accidentally turning the unit on or off, the On/Off button needs to be touched twice
within 6 seconds to turn it on or off. flashes, indicaes that the unit is running in Normal Cleaning mode.