JB Systems DynaSpot Operation Manual - Main Menu:
ENGLISH
USER MANUAL
JB SYSTEMS
®
4/59
DYNASPOT
MAIN MENU:
To select any of the functions, press the MODE button and use the DOWN / UP buttons to browse the
menu.
Select the function with the ENTER button (the display blinks).
Use DOWN and UP buttons to change the mode.
Once the required mode is selected, press the ENTER button to select.
Press the MODE button for about 2 seconds to store the setting and to return to
running mode. If you don’t do this, the setting will not be stored and after about 8
seconds, the fixture will return to the previous running mode.
DMX Address [Addr]
Used to set the starting address in a DMX setup.
Press the MODE and UP/DOWN buttons until
“
Addr
” is shown on the display.
Press the ENTER button.
Use DOWN and UP buttons to change the DMX512 address.
Once the correct address shows on the display, press the ENTER button to
select it.
Press the MODE button for about 2 seconds to store the setting and to return to
running mode.
Channel mode [ChMd]
Used to set the desired channel setup mode.
Press the MODE and UP/DOWN buttons until
“
ChMd
” is shown on the display.
Press the ENTER button.
Use DOWN and UP buttons to choose 5MSL, 8CH or 10CH mode.
Once the desired channel setup mode shows on the display, press the ENTER
button to select it.
Press the MODE button for about 2 seconds to store the setting and to return to
running mode.
Show Mode [ShMd]
Used to choose the Show mode when used in standalone or master/slave.
Press the MODE and UP/DOWN buttons until
“
ShMd
” is showing on the display.
Press the ENTER button.
Use DOWN and UP buttons to select one of the available shows:
Sh 1:
(Show 1) Fixture is placed
on the floor
. Tilt movement angle 210°.
Sh 2:
(Show 2) Fixture is fixed
under ceiling
. Tilt movement angle 90°.
Sh 3:
(Show 3) Fixture is placed
on a podium, in front of the audience.
The spot is always projecting to the
audience’s direction; i.e. in front of the
stage. Pan movement angle (left to right to left): 160°. Tilt movement angle:
90° (60° above horizon; 30° below horizon.)
Sh 4:
(Show 4) Fixture is fixed
under ceiling on the stage
. The spot is
mainly projecting in front of the stage. Pan movement angle (left to right to
left):160°. Tilt movement angle: 90° (vertically, front 75°; back 15°)
Once the desired mode is shown on the display, press the ENTER button to
select it.
Press the MODE button for about 2 seconds to store the setting and to return to
running mode.
Slave Mode [SLMd]
Used to make the slave unit work in opposite to the master or to work in
complete sync.
Press the MODE and UP/DOWN buttons until
“
SLMd
” is shown on the display.
Press the ENTER button.
Use DOWN and UP button to select Slave1 (normal) or Slave2 (2 light show)
mode.
Once the right mode is shown on the display, press the ENTER button to select it.
Press the MODE button for about 2 seconds to store the setting and to return to running mode.