JBL BALBOA-SUB10 Service Manual - - Contents -
- CONTENTS -
BASIC SPECIFICATIONS……………….….….….….…………….1
PACKAGING…………………………….………………………......2
DETAILED SPECIFICATIONS ……..…………….……………..3
CONNECTIONS..……………………………………………………5
OPERATION ………….……………………………..…………….7
TEST SET-UP AND PROCEDURE……..……….…….………….8
EXPLODED VIEW/PARTS LIST…………………………………..9
BLOCK DIAGRAM..……………………………………….…........10
120V ELECTRICAL PARTS LIST ……………………………….11
PCB DRAWINGS………………..………………………………...15
INTEGRATED CIRCUIT/TRANSISTOR PINOUTS…………..21
120V SCHEMATICS.……….…………….…………..…. ………22
BASIC SPECIFICATIONS
SUB10 Subwoofer
Frequency response:
27Hz – 150Hz
Amplifier Power output:
150W Continuous RMS power
Amplifier Peak Dynamic Power
†
:
250W
Crossover Frequencies
50Hz – 150Hz, 24dB/octave, continuously variable
Woofer:
10" (250mm) PolyPlas™ cone
Dimensions (including grille):
17-3/4" x 12-1/4" x 15-3/4" (451mmx311mmx400mm)
Weight:
32.1lb/14.6kg
† The Peak Dynamic Power is measured by recording the highest center-to-peak voltage measured across the
output of a resistive load equal to minimum impedance of the transducer, using a 50Hz sine wave burst, 3 cycles
on, 17 cycles off.
Occasional refinements may be made to existing products without notice but will always meet or exceed original
specifications unless otherwise stated
SUB10
Venture Series
1