JBL VTX A12 Rigging Manual - page 34

VTX A12 

| Rigging Manual

34

9.10 - ATTACHING THE ARRAY FRAME

The VTX A12 Array Frame was designed to be both lightweight and easy to handle whether it is transported on top of arrays or 

separately in a case.  Since the Extension Bar was designed to attach and travel on the Array Frame, these instructions assume this 

use case, although transportation together is recommended, it is not required.  

STEPS:

•  To make it easier to attach, separate the Array Frame from 

the Extension Bar.

•  Ensure that the top cabinet is set to the correct angle and 

ensure that the Array Frame is oriented in the proper di-

rection. Lift the frame over the top A12 cabinet on the cart 

and  place it resting on the 4 QRP attachment points on the 

top of the cabinet.

•  Remove the QRP’s from their storage positions and place 

each one into its respective attachment position.  The QRP’s 

should be attached from the inside of the Array Frame.

•  Once the Array Frame is secured to the top of the cabinet, 

the Extension Bar can be attached.  Confirm its correct ori-

entation by consulting the LAC and ensure that the correct 

A, B, or C position is attached using both of the included 

large-gauge QRP’s.