Jcb MC300 Safety And Operating Manual - Mounting / Changing

JCB, SO53 3LE

www.JCBDIY.com

Customer Helpline 0333 0143092  

MOUNTING / CHANGING 

THE MESH SANDING 

SHEET(See D,E) 

2a) Flip the tool-less blade change 

lever (1) forward to the open 

position to loosen the flange (7). 

Remove universal end cut blade. 

Insert the sanding pad (12) onto 

the accessory interface (6), then 

(if necessary, re-insert the flange) 

press down the flange with finger to 

keep the blade temporarily secure. 

Flip lever (1) back down to seated 

position to secure accessory.

2b) Place the mesh sanding sheet 

directly onto the base plate and 

press the sheet onto the pad. Firmly 

press the oscillating tool with the 

installed sanding sheet against a flat 

surface and briefly switch the power 

tool on. This provides for good 

adhesion and prevents premature 

wear. If one point has become worn 

after use, pull off the sanding sheet, 

turn it 120°, and re-install.

2. OPERATING THE ON/

OFF SWITCH 

——Switching the power tool ON:

Slide switch forward.

——Switching the power tool OFF:

Slide switch backward.

3. USING THE VARIABLE 

SPEED DIAL

Select oscillation frequency (speed) 

while the motor is running.

The Variable Speed Dial can 

A

A

A

2

D

B

E

2

3

I

I

2

I

I

K

N

N

G

G

C

K