Jcb MC300 Safety And Operating Manual - Working Hints For Your Tool:

JCB, SO53 3LE

www.JCBDIY.com

Customer Helpline 0333 0143092  

WORKING HINTS FOR YOUR TOOL:

If your power tool becomes too hot, especially when used at low speed, set the 

speed to maximum and run it with no load for 2-3 minutes to cool the motor. Avoid 

prolonged usage at very low speeds. Always keep the blade sharp.

Always ensure the workpiece is firmly held or clamped to prevent movement.

Any movement of the material may affect the quality of the cutting or sanding 

finish.

Start your tool before working and turn it off only after you stop working. 

Do not start sanding without having the sandpaper fitted.

Do not allow the sandpaper to wear away, it will damage the sanding pad. The 

guarantee does not cover sanding pad wear and tear.

Use coarse grit paper to sand rough surfaces, medium grit for smooth surfaces 

and fine grit for finishing surfaces. If necessary, first make a test run on scrap 

material.

Excessive force will reduce the working efficiency and cause motor overload. 

Replacing the accessory regularly will maintain optimum working efficiency.

MAINTAIN TOOLS WITH CARE

Remove the plug from the socket before carrying out any adjustment, servicing 

or maintenance.

There are no user serviceable parts in your power tool. Never use water or 

chemical cleaners to clean your power tool. Wipe clean with a dry cloth. Always 

store your power tool in a dry place. Keep the motor ventilation slots clean. Keep 

all working controls free of dust. Occasionally you may see sparks through the 

ventilation slots. This is normal and will not damage your power tool.

If the supply cord is damaged, it must be replaced by the manufacturer, its service 

agent or similarly qualified persons in order to avoid a hazard.

ENVIRONMENTAL PROTECTION

This product has been marked with a symbol relating to removing electric 

and electronic waste. This means that this product shall not be discarded 

with household waste but that it shall be returned to a collection system which 

conforms to the European Directive 2012/19/EU. It will then be recycled or dismantled 

in order to reduce the impact on the environment. Electric and electronic equipment 

can be hazardous for the environment and for human health since they contain 

hazardous substances.