Jeanneau 57 Instruction Manual - page 77
The boat may be fi tted with an optional watermaker (100 litres/hour) located
under the port settee in the saloon.
OPERATION
The watermaker works either in 24V, or in 230V.
Check its automatic breaker is set to ‘on’ on the 230V # 3 panel in the cup-
board behind the chart table seating.
Check its sea water supply valve is open (access under the port front fl oor-
board in the saloon).
The watermaker circuit gives four possible destinations for the water, among
which three for the storage in the tanks, and one for the storage in bottles.
To choose a tank as a destination of storage:
- Select on the control panel of the watermaker (access behind the back of the
port settee) the option ‘fresh water cistern’.
- Select the desired tank by opening its valve (under saloon fl oorboard).
To choose a bottle as a destination of storage:
- Select on the control panel of the watermaker (access behind the back of the
port settee) the option ‘fresh water valve’.
The water will be sent to the pourer on the galley sink.
The circuit of the foot pump will be neutralized during this operation.
SUPPLY
Select the source of supply (24V or 230V) using the selector on the control
panel of the watermaker (access behind the back of the port settee).
Then if need be, select the 230V source (generator) using the selectors B
and C on the 230V selection panel in the cupboard behind the chart table
seating.
Start the watermaker using its control (behind the back of the port settee).
Check the level of fresh water in the tanks when the watermaker is working.
Regularly clean its fi lter located under the saloon fl oorboard.
For the use and maintenance of the watermaker, please refer to its instruction
guide.
WATER SYSTEMS
6.5
WATERMAKER
75
6