K-sun BEE3-EZ Operator's Manual - Printer Set-Up

4

1.  Tighten the ribbon.

         2.  Open the cover   

3. Insert the cartridge.

a. Insert the cartridge with its label side up. 

b. Straighten the tape end.  

c. Push the tape end through the tape guide

              4.  Close the cover.

Note:  How to remove the tape cartridge

To remove, place your fingers on the tabs provided on both sides of the 

cartridge as shown in the figure, lift the tabs straight up to pull out the 

cartridge.

Printer Set-Up

1

2

3

a

b

c

4

5. Connect the adapter to the printer. Connect the cord to 

the adapter then plug into the wall outlet. USE ONLY 

ADAPTER MARKED K-Sun® APT0615Y1-1

6. Turn on printer.  

7. Feed and cut the tape to clear slack in 

     ribbon and tape. Press Shift and the 

     Print/FeedCut key. Display will say 

     “Feed & Cut.” Press Return and tape 

     will feed and cut.

Note:  For supplies that require manual cutting (using scissors), Use the down  Arrow key at Feed 

& Cut. Your screen will say “Feed.” Press Return and tape will feed.  

6

7

Prin

ter S

et-Up

Feed/Cut

5