Kaba access control 2941 indiana avenue winston-salem, nc 27105 usa tel: (800) 849-8324 (336) 725-1331 fax: (800) 346-9640 (336) 725-3269 www.Kaba-ilco.Com www.E-plexlock.Com installation instructions 2 0 0 0 for technical assistance, call 1-800-849-tech (8324) or 336-725-1331 between 8 am & 5 pm es...
3 checklist parts and tools list each e-plex 2000 lockset includes: • outside lock housing • inside lock assembly • outside lever • gasket for outside lock housing • cylindrical latch • cylinder drive unit • battery holder with 3 aa batteries • drilling template • hardware bag, includes: - square sp...
5 (a) lock housing (b) inside drive hub (c) nylon washer (d) spring washer (e) drive tube (f) lever catch (g) countersink (h) outside lever (i) cap (j) cylinder (k) cylinder plug diagram of lock: back front (a) (e) (b) (d) (f) (g) (h) (i) (j) (k) (c) 4 tools required: important: for doors more than ...
Screws cylindrical unit assembly 7 b-2 remove the two connecting screws from the cylindrical drive unit. Rotate cylindrical drive unit 180 º . Reposition spacer(s) as found before disassembly. Remount drive unit with the two connecting screws. C. Door thickness the cylindrical unit and plate assembl...
9 e. Reversing the outside lever for series without mechanical override the lever is field reversible. If the handing is incorrect, insert a small pick or flat screwdriver in the hole in the hub as shown. Gently pry back the spring clip inside the hub, and remove the handle. F. Installing optional k...
11 f-7 for right-handed levers: turn the key approximately 90 º clockwise so that it is in the vertical position and the countersink (g) is in the top position. For left-handed levers: turn the key approx- imately 90 º clockwise so that it is in the verti- cal position and the countersink (g) is in ...
F-10 remove the key. The lock will look as shown at right. F-11 gently check the rotation of the lever handle. It should easily rotate approxi- mately 45 º . Troubleshooting: if you have assembled the lever and housing with the key in the wrong position, the key will get stuck. To remove the key, tu...
14 h-2 with the lever (h) in the horizontal posi- tion, insert the key (n) into the cylinder and turn it clockwise until it stops. (this applies to both right and left-handed locks.) h-3 let go of the key, and again turn the lever handle (h) clockwise for right-handed locks or counter-clockwise for ...
16 j. Installing lock housings j-1 insert the slotted end of the square spindle into the outside lever hub until it locks, at an angle of 45 º . (the spindle can be removed by pulling on it, if oriented incorrectly.) j-2 assemble gasket onto the out- side housing (a). Assemble cylindrical plate asse...
18 l. Testing the operation of the lock l-1 rotate inside lever and hold. Ensure that the latch is fully retracted and flush with the latch faceplate. Release the inside lever; the latch should be fully extended. L-2 enter the factory-set combination: 1,2,3,4,5,6,7,8. You should see a green light an...
