Kaco Powador-proLOG Operating Instructions Manual - And Operation
Operating Instructions Powador-proLOG_EN
Page 7
3 Notes on Installation
and Operation
3.1 Intended use
The Powador-proLOG is used for solar power system monitor-
ing of the photovoltaic system.
It records the currents, voltages, temperatures, power and
yields of every individual inverter, as well as the values of the
externally connected sensors.
The Powador-proLOG is built according to the state of the art
and recognised safety rules. Nevertheless, improper use may
cause hazards for the operators or result in damage to the
units.
Any other or additional use is not considered the intended use.
The manufacturer/supplier is not liable for damage caused by
such unintended use. This risk is borne solely by the operator.
Intended use also includes adherence to the operating instruc-
tions.
3.2 Factory warranty and liability
KACO new energy GmbH grants a warranty of two years on
the Powador-proLOG starting from the date of shipment by
KACO new energy GmbH.
During this time, KACO new energy GmbH guarantees the
proper function of the units and to undertake repairs at the
factory free of charge in the event of a defect for which we are
responsible.
Contact your specialty dealer if your unit exhibits a defect or
fault during the warranty period.
Warranty claims are excluded in the following cases:
–
Use of the units in ways not intended
–
Improper installation or installation that does not comply
with standards
–
Improper operation
–
Operating the unit with defective protective equipment
–
Unauthorised modifications to the units or repairattempts
–
Influence of foreign objects or force majeure (lightning,
overvoltage, severe weather, fire)
–
Failure to observe the relevant safety regulations
–
Transport damage
All warranty claims must be handled at the premises of KACO
new energy GmbH. Where possible, the unit must be returned
in its original or equivalent packaging. The costs for these
services cannot be borne by KACO new energy GmbH.
KACO new energy GmbH will only perform warranty services
if the defective unit is returned to KACO new energy GmbH
together with a copy of the invoice which was issued to the
user by the dealer. The name plate on the unit must be fully
legible. If these requirements are not fulfilled, KACO new
energy GmbH reserves the right to deny warranty services.
3.3 Service
We place special emphasis on the quality and longevity of our
data loggers, starting with the product development phase.
However, despite all quality assurance measures, faults may
occur in rare cases. In such cases, KACO new energy GmbH
will provide you with the maximum possible support. KACO
new energy GmbH will make every effort to remedy such
faults in an expeditious manner and without a great deal of
bureaucracy. In such cases, contact our service department
directly.
Telephone: +49(0)7132-3818-690
Section 3 ·
Notes on Installation and Operation