Kaffee Konzepte FK-series User Manual - page 16
FK Range - Coffee dispensers
- 16 -
Firmware version
This shows the version of the firmware installed in the processor and the date it
was compiled.
Display shows:-
Firmware V: VX.X.X
Comp DD-MMM-YY
EEPROM software version
This shows the version of the software installed in the EEPROM
Display shows:-
EEPROM ver XXX
.
Water sensor calibration
This function shows the water level sensor readings and the TRIP POINT at
which the dispenser decides whether the tank is full of water or not.
Display shows:-
Water read XX
Trip point XX
The current water level reading is shown in the display and may be adjusted by
pressing the UP arrow () button to allow more water into the tank or the DOWN
arrow () to lower the water level by dispensing it through the nozzle.
If the Water reading is lower than the TRIP POINT, then the tank is full.
If the Water reading is higher than the TRIP POINT, then the inlet valve will turn
on until there is sufficient water in the tank that the Water reading is lower than
the TRIP POINT.
Adjusting the TRIP POINT
This function allows the TRIP POINT to be adjusted to allow for differing water
quality. The standard reading for the TRIP POINT is 45.
Use or buttons to set this function type
The button will raise the TRIP POINT
The button will lower the TRIP POINT
Setting the TRIP POINT close to the Water reading will increase the sensitivity
and should be attempted with caution.