Kaiser Baas GAMMA User Manual - Drone/transmitter Binding

EN

GAMMADRONE | User Guide

16

DRONE/TRANSMITTER BINDING

To  operate  your  Drone,  you  must  first  bind  the  Drone  to  your  Transmitter  before  every 

flight. 

Ensure your Drone and Transmitter are fully charged and follow these steps in order:

1. Turn on your Drone by holding the power button for 1.5 seconds.

2. The Drone lights will flash indicating it is ready to bind to a Transmitter.

3. Turn on the Transmitter.

4. Using the Left Throttle/Yaw Stick move it to the maximum UP position and return it 

back to the zero position.

Note: you must complete this process within 5 seconds of powering on the 

Transmitter or you will have to restart the process.

5. The Drone LED lights will stop flashing indicating the Drone is now paired to the 

Transmitter.

DRONE CALIBRATION

Before every flight it is important to calibrate your Drone. 

Calibration ensures the Gyroscopes are reset and the Drones Direction/Heading is fixed. 

Always calibrate with the Drone and the Pilot facing the same direction. 

Calibration:

1. Place the Drone on level ground facing the same direction as the pilot.

2.  Push the Left Throttle/Yaw Stick and the Right Pitch/Roll Stick to the bottom left and 

hold for 2 seconds until you see the LED indicator lights on the drone start to flash 

rapidly. 

3. Release the sticks and wait for the drone LEDs to stop flashing. 

4. The Drone LEDs will stop flashing indicating that the calibration has been completed.

1 2