Kaiser Baas X-BEAM Complete User Manual - page 5
7
8
Ensure that your X-Beam Action Camera
Light is fully charged before use.
Battery Operation
Removing the battery
1. Lift the clip on the top of the X-Beam
Action Camera Light to reveal the
battery housing.
(Fig. A)
2. Slide the battery out of the housing.
(Fig. B)
1. To charge your X-Beam Action
Camera Light, connect the provided
Micro USB cable.
2. Connect the USB cable to an
electronic device with a USB port.
3. A full charging cycle will take approx.
3 hours by 1A/2.1A charger.
4. A red light indicates the battery
is charging.
5. A green light indicates the battery
is fully charged.
Set up Your X-Beam
Recharging the Battery
Fig. A
Fig. B
Note: If using a wall charger, ensure
that it is a certified product for
your region. AC Input: 100-240VAC
50/60Hz. DC Output: 5VDC 1A/2.1A.
Only use a USB charger with
suitable approval and certification.
Do not charge in conditions outside
of the 10°C-45°C range.
LI
-ION
Input: 5VDC 2.1A
Rechargeable Li
-ion battery
3.7VDC 2200mAh 8.14Wh
CHARGE COMPLETE
CHARGE
IN
PROGRESS
DISASSEMBLE OR EXPOSE THE BATTERY
TO FIRE OR WATER. RISK OF FIRE AND
BURNS. DO NOT OPEN, CRUSH , HEAT
ABOVE 60°C OR INCINERATE. FOLLOW
MANUFACTURER’S INSTRUCTIONS.
CAUTION:
DO NOT SHORT CIRCUIT,
Manufacturer: GREAT POWER BATTERY(ZHUHAI)CO.,LTD.
DATE:2016-05-01
Model: BP-01
Great Power 062540
IEC: 1ICP7/26/41-4
Indicators
Charging
Charged