Kaiser Baas X-BEAM Complete User Manual - page 6
9
10
• Insert the battery into the light, close
the housing and snap the clip closed.
Refer to Fig. A and Fig. B
• The On / Off switch is located on the
top of the X-Beam Action Camera
Light and is used to power on the
device and to change the light modes.
• Press and hold the power button for
2 seconds to turn the X-Beam on.
• Hold the power button for 6 seconds
to turn the X-Beam off.
Operating Guide
Fig. B
Fig. A
Lighting Mode Specifications
Modes
Wide
Ambient
Target
Lumens
1000/500
700/350
300/150
Battery
0.5/1 Hr
0.75/1.5 Hr
1.5/3.5 Hr
Cree Leds
6 Led
4 Led
2 Led
There are 3 modes of operation for the
X-Beam Action Camera Light. Each mode
has a High and Low light setting. They
cycle through in the following order:
Wide Angle High, Wide Angle Low,
Ambient High, Ambient Low,
Target High, Target Low, Off
Modes of Use
To cycle between the different modes
Whilst the light is on click the power
button. Continue to click the button to cycle
through. The light will turn off after a cycle.