Kalenji CW Kalenji 700 GPS User Manual - page 24
The menu “change capacity” lets you alter the capacity of available storage. You can increase this capacity by selecting a 5 second-sample rate.
Conversely, if you want maximum accuracy, you can choose a sample rate for each second. In this case the storage capacity will be halved
relative to the default value (2 seconds).
To change the storage capacity, choose “change capacity” and press
OK. Use the and keys to increase or decrease the sample range. You
will notice an immediate effect on the number of recording hours available.
Chapter
19.8. The watch’s memory is low
.
16 Settings
settings
The setting menu contains all the parameters necessary to configure and update your watch.
16 1 Activity options
As the activity options are specific to each mode (free session, training, challenge), they can only be accessed via the settings menu when an activity has
been paused.
Activity options can always be accessed from the searching for satellite signal screen. For further information, consult the description of each mode.
16 2 Personalising the interface
In this menu, you can amend all the necessary parameters so that the watch can provide all relevant information.
16 2 1 Display
In this menu, you can configure the “my indicators” display described in chapter
9.3.2 My indicators display
.
Adjust the number of information pages that you wish to use (1-4 pages).
Then select the pages to set the information on each page.
3
number of lines
on page
Choose the number of the information item (1-4) required from selected page.
0
--
M
km/h
00'00''
00
Select one piece of information to amend and press
OK.
You will be able to access a list of available indicators, as illustrated here.
Select the category of indicators chosen using the and ▲ keys then press
OK.
Depending on the category of indicators chosen, you can choose to have instant, average, minimum or maximum values for the entire session or lap.
Use the ▲ and key to make your choices and press
OK to confirm or to go back.
List of available indicators
1
Time: the time
If you wish to consult the time during your session, leave this indicator on one of the pages.
2
Stopwatch: the stopwatch
- Beginning: from start of session.
- Lap: from the start of lap.
3
Speed: speed in km/h
- Instantaneous: instant speed.
- Average: Average speed during session or lap.
- Maximum: highest speed reached during session or lap.
4
% MAS: your speed expressed as a percentage of your maximum aerobic speed (the maximum aerobic speed should have been provided).
See chapter
11.3 Maximum aerobic speed
)
- Instantaneous: instant % of MAS.
- Average: average % of MAS during session or lap.
- Maximum: highest % of MAS during session or lap.
5
Pace: pace in minutes/km
- Instantaneous: instant pace.
- Average: average pace during session or lap.
- lap: from the start of lap.
6
Distance: distance covered
- Total: from start of session.
- Lap: from the start of lap.
personallzed
interface
set page 1
set page 2
set page 3
set page 4
values
time
stopwatch
speed
%
MAS
24