Kanguru Media X-Change 2.0 User Manual - page 10
When Media X-change 2.0 is connected to the computer, the "Transfer" icon keeps
flashing during data transfers, when inserting a memory card into the slot, the
corresponding icon will appear and also flashes during data transfer.
DO NOT:
1. Disconnect unit from the computer until the icon stops flashing
2. Remove memory card(s) from the card slot during a transfer, which may cause
lost or corrupt data.
Under Windows 98SE, the Media X-change should be connected to the system before
the driver has been installed.
Under Windows 2000 Professional, the Media X-change should be connected to
the system before the driver has been installed, only one Removable drive will appear in
My Computer, corresponding to the SD/MMC/MS memory slot. In this case, the driver must
be installed and then it must be updated by means of the Device Manager.
The Media X-change is supported by the native MacOS X USB extensions, but DOS
volumes are not adequately supported by MacOS 10.0.x and loss of data can occur.
Upgrading to version 10.1 or later is mandatory.
9 Kanguru Media X-change 2.0