Kanto OASIS User Manual - page 5
Supporting your digital lifestyle
™
Supporting your digital lifestyle
™
5
Step 2: Attach Backing Board to Frames
Step 2.1 Position Backing Board.
Position the Backing Board (F) against the back of the
Oasis TV Stand, oriented as shown in Diagram B.
Step 2.2 Start All Six Bolts.
Starting with the top set, start the left and right M4 x
15mm bolts (B). Choose the correct set of holes on the
Backing Board to align to your chosen frame height, and
start those bolts. Finally, start the two bottom bolts.
Step 2.3 Align Top Center Hole.
To help your alignment when it’s time to attach the Back
Frame in Step 3, insert an M6 x 32 mm Bolt (A) through
one of the two top center holes of the Backing Board
and into the Top Frame (H).
Step 2.4 Tighten the Bolts.
Using a Philips screwdriver, tighten all six screws. You can
now remove the M6 x 32 mm Bolt (A) used for alignment.
The Backing Board (F) is a black painted solid MDF board that can be attached with either side facing forward. You will
be able to route your cables through the cable management holes for a clean finished look.
Diagram B
A
(insert
temporarily)
B
(x6)