Kanto OASIS User Manual - page 6
6
Step 3: Attach Rear Support Frame and Rubber Bumpers
Step 3.1
Position Rear Support Frame.
The Rear Support Frame (G) has five sets of captive nuts
on the front, and only two sets of captive nuts on the rear,
as shown in Diagram C. Position the Rear Support Frame
(G) facing front, as shown in Diagram D. A Kanto Stand
Mount, if you have purchased one, can attach to the rear
of the Rear Support Frame.
Step 3.2
Start Six Bolts.
Manually start six M6 x 32 mm bolts (A) into the six captive
nuts, tightening them each approximately halfway, as
shown in Diagram D.
Step 3.3
Tighten the Bolts.
Tighten the six M6 x 32 mm bolts (A) using the Allen Key
(D) provided.
Step 3.4
Place Rubber Bumpers.
Place six rubber bumpers (C) on the top of each frame,
positioned near each end and the middle, as shown for the
top shelf in Diagram D. Bumpers are only shown for the
front rail of the middle and bottom frames.
Diagram D
The Rear Support Frame provides added strength to the Oasis stand, and will allow you to attach a Kanto Stand
Mount (packaged separately) if you have purchased an Oasis Plus model, or added the Stand Mount later.
front view
rear view
Diagram C
C
(x18)
A
(x6)
G