Kaption Audio 570-MKZ2000X1 Owner's Manual

Manual is about: 2000w

Summary of 570-MKZ2000X1

  • Page 1

    2000w mono block amplifier owner’s manual 570-mkz2000x1.

  • Page 2: Introduction:

    Introduction: congratulations on your new purchase of kaption audio amplifier. These amplifiers are engineered to reproduce music that is so detailed, you will hear music in a whole new truly superior product. We always recommend you have these amplifiers installed by an authorized kaption audio dea...

  • Page 3: Pre- Installation

    W arning i nvestigate the layout of your automobile thoroughly before drilling or cutting any holes . U se extreme care when you work near the gas tanks , gas or hydraulic lines , and electrical wiring . A lways make sure the a mplifier is securely mounted . M ounting the a mplifier securely to the ...

  • Page 4: 570-Mkz2000X1 Parts List

    570-mkz2000x1 parts list • 2000w mono block amplifier • wired bass remote control • hardware pack [55] 2.16 [236] 9.29 [510] 20.08 - 3 - 2000w mono block amplifier.

  • Page 5: 1.  Speaker Terminals

    Controls and wiring locations 1. Speaker terminals terminals outputs to sub-woofer(s). See wire diagrams for the type of sub-woofer the amplifier will be connected to. 2. +12 volt power connection. Th amplifier must be connect to the positive terminal on the vehicle’s battery. A fuse must be connect...

  • Page 6: 5.  Rca Input Jacks

    5. Rca input jacks rca input jacks are for use with source units output signal. Source units with an output signal level of minimum 200mv to 9v may be used. (see wiring diagrams) 6. Rca output jacks rca output jacks are for use to connect a second amplifier. Line level “pass-through” from the rca in...

  • Page 7: 14.  Power Indicator

    13. Input slave/output master mode this mode switch is used to combine two amplifiers together to power large sub-woofer(s) for a single amplifier configuration, use the mode switch in the “output master” position. For a dual amplifier configuration, master amplifier is the first unit connected to t...

  • Page 8

    Is something that you do not feel comfortable doing, please ask a professional to help you. Be sure to lay the power wire away from all signal cables. • +12v (item 2): this is the main power input for the amplifier and must be connected directly to the positive terminal of the car battery for the am...

  • Page 9: Speaker Wiring Diagram

    Speaker wiring diagram fuse source unit source unit right (r) left (l) master slave fuse source unit source unit right (r) left (l) master slave single woofer setup fuse source unit source unit right (r) left (l) master slave fuse source unit source unit right (r) left (l) master slave single amplif...

  • Page 10: Of Both Amplifiers.

    Dual amplifiers in master/slave configuration, singe sub-woofer o nly use two 570-mkz2000x1 amplifiers together to build a m aster /s lave configuration . D o not use amplifiers of different types or models together . 1. Choose one amplifier and set the “input slave/output master” mode switch to “ou...

  • Page 11

    Fuse source unit source unit fuse source unit right (r) left (l) master slave master slave slave amplifier master amplifier sub-woofer 2-8 Ω 6. Connect the sub-woofer with appropriate wires to the terminal block (speaker output - and +) of both amplifiers. Connect the (-) terminal on the master amp ...

  • Page 12: Troubleshooting Guide

    Troubleshooting guide problem causes and solutions power indicator is not lit a. Check +12 volt wire fuse blown and replace if needed b. Check remote turn on +12v and gnd connections ensure the ground is secured to clean metal on the vehicle chassis. C. Source unit not functioning properly power ind...

  • Page 13: Specifications

    Specifications model 570-mkz2000x1 description 2000w mono block continuous power @ 14.4v 1Ω load 2000w 2Ω load 1500w 4Ω load 850w features input sensitivity 0.2v-9v frequency response 15hz to 250hz low pass filter 35hz to 250hz subsonic filter 15hz to 35hz s/n ratio >95 db thd+n at 4 ohm load rated ...

  • Page 14: What Is Not Covered

    Limited warranty information: kaption audio amplifiers have a one-year limited warranty. This warranty covers the original purchaser of a kaption audio speaker, purchased from an authorized kaption audio dealer. In order to receive service, proof of purchase is required stating the customers name, d...

  • Page 15: Warranty Registration Card

    Warranty registration card name: ________________________________________________ street: ________________________________________________ city: ________________________________________________ province / state: ________________________________________________ country: ______________________________...

  • Page 16: Kaption Audio

    Kaption audio 95 cousins drive aurora, ontario canada, l4g 1b5 www.Kaptionaudio.Com 866-kaption (527-8466) designed in canada; made in china r0 (06/15).