Kaption Audio 570-MKZ2000X1 Owner's Manual - 5. Rca Input Jacks
5. RCA Input Jacks
RCA Input jacks are for use with source units output signal. Source
units with an output signal level of minimum 200mV to 9V may be
used. (See wiring diagrams)
6. RCA Output Jacks
RCA Output jacks are for use to connect a second amplifier. Line level
“pass-through” from the RCA Input jacks, providing an un-amplified
input for a second amp
7. Level (Gain) Control
Use the Level Control to fine-tune the input sensitivity of the amplifier
to the source unit’s output level. The operating range is from 0.2V to
9V. This is NOT a volume control!
8. Phase Setting
Phase controls the signal input timing, shifting the signal from 0° to
180°. Adjust to match the sub-woofers to other acoustic timing
9. Wired Bass Remote Jack
Provides a wired remote control to the drivers seated location. The
Bass Remote controls the amplifier’s volume adjustment.
10. Bass EQ
Bass EQ will increase the bass level by 0B to +10dB, centred around
45Hz by setting the dial to the desired position.
11. Subsonic Filter
The Subsonic is adjustable to filter out undesirable low frequencies
from 15Hz to 35Hz. This setting can prevent low frequency damage to
the sub-woofer.
12. LPF (Low Pass Filter) Control
The LPF controls the low pass crossover to select the desired
frequency. The frequency can be adjusted from 35Hz to 250Hz.
1
3
2
4
5
6
7
8
9
10
11 12
13
17
18
15
14
16
- 5 -
2000w Mono Block Amplifier