Kaption Audio 570-MKZ2000X1 Owner's Manual - page 11
FUSE
SOURCE UNIT
SOURCE UNIT
FUSE
SOURCE UNIT
RIGHT (R)
LEFT (L)
MASTER
SLAVE
MASTER
SLAVE
SLAVE AMPLIFIER
MASTER AMPLIFIER
SUB-WOOFER
2-8 Ω
6. Connect the sub-woofer with appropriate wires to the terminal block
(SPEAKER OUTPUT - and +) of both amplifiers. Connect the (-) terminal on
the master amp to the (+) terminal on the speaker, Bridge the master ‘s (+)
terminal to the slave amp’s (+) Terminal. To finish, connect the Slave’s (-)
terminal to the speaker’s (-) terminal.
As optional feature an additional Sub-woofer can be connected to the
non-occupied terminals of the amplifiers.
The minimum final sub-woofer impedance must not be lower than 2 Ohms
total (1 Ohm for each Amplifier) or 2 Ohms bridged. Too low speaker
impedance load will result in too high heat dissipation and may cause the
amplifier enter protection mode or damage the sub-woofer.
f
Or
OThEr
WIrINg
CONfIgUrATIONs
fOr
AmplIfIEr
ANd
sUB
-
WOOfEr
CONfIgUrATION
,
plEAsE
CONTACT
yOUr
A
UThOrIzEd
K
ApTION
d
EAlEr
Or
K
ApTION
A
UdIO
- 10 -
2000w Mono Block Amplifier