Karcher HDS 551 C Eco Instruction Manual - Warranty
English
35
– Direction of rotation is wrong. With cor-
rect direction of rotation a strong airflow
can be felt out of the exhaust opening of
the burner.
Î
Check direction of rotation. If necessary
have connection replaced by electrical
specialist.
– No ignition spark
Î
If device is in use and no ignition spark
can be seen through the viewing glas,
have device checked by customer serv-
ice.
– Working pressure/flow rate to high
Î
Reduce working pressure/flow rate
through regulating spindle (Figure 6).
– Sooty heating spiral
Î
Have device de-sooted by customer
service.
If malfunction can not be fixed, the de-
vice must be checked by customer serv-
ice.
The warranty terms published by our com-
petent sales company are applicable in each
country. We will repair potential failures of
the appliance within the warranty period free
of charge, provided that such failure is
caused by faulty material or defects in fabri-
cation.
The warranty comes only into effect if your
vender fills out the supplied reply card com-
pletely at purchase, stamps and signs and
you send it to the local distribution company
of your country.
In the event of a warranty claim please con-
tact your dealer or the nearest authorized
Customer Service centre. Please submit the
appliance, including all accessories, and the
proof of purchase.
– Only use accessories and spare parts
which have been approved by the manu-
facturer. The exclusive use of original ac-
cessories and original spare parts
ensures that the appliance can be oper-
ated safely and troublefree.
– At the end of the operating instructions
you will find a selected list of spare parts
that are often required.
– For additional information about spare
parts, please go to the Service section at
www.kaercher.com.
– The accident prevention regulation
(BGR 500) "Work with liquid rays" is val-
id. High pressure spraying units must be
checked every 12 months in accordance
with these guidelines by an expert and
the result of this check must be written
down.
– Operating procedures create short term
power sinkings.
– During unfavorable net conditions other
devices might be disturbed.
– With a net impedance lower then 0,15
Ohm no disturbances are to be expect-
ed.
We hereby declare that the machine de-
scribed below complies with the relevant ba-
sic safety and health requirements of the EU
Directives, both in its basic design and con-
struction as well as in the version put into cir-
culation by us. This declaration shall cease
to be valid if the machine is modified without
our prior approval.
Set temperature is not achieved
while using hot water
Warranty
General notes
Accessories and Spare Parts
Guidelines for liquid rays
Operating procedures