Karcher K 2.400 Operating Instructions Manual - page 7
English
7
Assemble appliance as shown on page 6
Mount loose parts delivered with appliance
prior to start-up.
Illustration
Insert the transport wheels and lock
them.
Illustration
Attach the transport handle /carrying
handle.
Illustration
Fasten the quick coupling for the high
pressure hose to the high pressure con-
nection.
Illustration
Push the high pressure hose into the
trigger gun until it locks audibly.
Note:
Make sure the connection nipple
is aligned correctly.
Check the secure connection by pulling
on the high pressure hose.
Illustration
Pull the suction hose for detergent
through the cover of the detergent tank
until the filter contacts the bottom of the
tank.
Close the detergent tank with the lid.
Lock the detergent tank in place on the
appliance.
According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply
without a system separator. Use a
suitable system separator manufactured by
KÄRCHER; or, as an alternative, a system
separator as per EN 12729 Type BA. Water
flowing through a system separator is con-
sidered non-drinkable.
Caution
Always connect the system separator to the
water supply, never directly to the appliance!
Note:
Impurities in the water can damage
the high-pressure pump and accessories.
For protection, the use of the KÄRCHER
water filter (optional accessory, order no.
4.730-059) is recommended.
Observe regulations of water supplier.
For connection values, see type plate/tech-
nical data.
Use a fibre-reinforced water hose (not
included) with a standard coupling.
(Minimum diameter 1/2 inch (13 mm),
minimum length 7.5 m).
Illustration
Screw the coupling element to the wa-
ter connection on the appliance.
Push the water supply hose onto the
coupling unit, then connect it to the wa-
ter supply.
KÄRCHER recommends using the suction
hose accessory (sold separately) Order no.
9.505-779.0.
STEP 1:
Connect the suction hose to the water
inlet on the pressure cleaner and drop
the other end into a bucket.
Tip
: If you are not using this accessory, coil
a hose into the bucket and ensure that you
only use a standard hose clamp to connect
to the pressure washer.
CLICK FITTINGS MUST NOT BE USED!
STEP 2:
Fill up your bucket with water.
STEP 3:
Connect the KÄRCHER power cord to
an electricity source and turn on at pow-
Before Startup
Water supply
Water supply from mains
How to draw water from a bucket when
using a KÄRCHER Pressure Cleaner