Karcher KA 1015 User Manual - page 27
EN | 27
EN
than the cabinet overhang.
Cabinet overhang
Washer
Cabinet bottom
Equal to or longer
than cabinet over-
hang
Selected screws which
meet minimum, but do not
exceed maximum length
Step 5
Insert screws from inside the cabinet. The washers must be used on metal cabinets, and on wood
cabinets if you did not countersink the drilled holes. Position washers, flat side down, and place
screws into the holes.
If your cabinet does not have an overhang, go to Step 7.
Step 6
Hold screw heads down while you push the selected spacers onto the screws under the cabinet.
Be sure to push up spacers until they fully nested (if more then one is in used).
Step 7
Align radio under the screws. Hold the screw holes in the top of the clock radio against the mounting
screws and partially tighten the screws.
Do not fully tighten until all 3 screws have been started (the top front edge of the clock radio should
clear the overhang.).
Power Wire Holder
It is for round the extra power wire after user had plugged the power cord to the electrical outlet.
LCD
Power Supply
Connect the power cable to a suitable power outlet. Make sure that the output power of the outlet
matches the power indicated on the unit’s rating label.